Posts Tagged ‘Firmware’
The most significant innovations are the commands get pattern and set counter.
Retrieves the digital input state as pattern with Get pattern. The current input state must have not changed.
Set counter allows to set the counter to a desired value. Counting starts from this value.
Both functions can be used as a direct command or with the new configuration tools.
In addition, other innovations have been introduced. Here is a short list:
Customized item logging into a file LogFile.txt (Log to File) is possible, now.
Get Pattern / Event Filter
With Get Pattern the pattern status for all digital inputs can be retrieved manually.
In addition, with "Event Filter" update messages of individual digital inputs can be specifically excluded.
The state of a digital input can be requested specifically with the buttons GetStateBit0 … GetStateBit5.
With "Set to Counter", the counter can be set to a desired value.
Interrupt the cyclic transmission of a temperature value with the Stop button. With the Start button the temperature value is again transferring cyclically.
For example, if the transmission cycle is 10 minutes and only one minute of the cycle has passed, click start/stop and do not wait nine minutes to get a new temperature value.
Firmware and drivers of our virtual COM-Port
ipEther232 have been updated.
Firmware 14.03: A small bug with the RS485 two-wire communication was fixed.
The firmware 14.03 can be used with the configtool version 12 as well as with version 14.
For older ipEther232 versions, please take a look at the firmware update page.